Air Pressure rod: 6 bar ( 4.5 bar min), Min pressure required 5 bar. Air Consumption: Low Stroke at roll centre: 50 mm Force available at roll centre at max. pressure: 450Kgf Range of contact Pressure at Palm ( can be set) : 0.250 gram to 0.750 gram. Overall size: length x width x height ( Excluding palm assembly) 70 cm x 20 cm x 60 cm. Weight : 50 kgs. Lay out and mounting dimensions Enquire
	This is a full fledged servo-system using pneumatic pressure as energy source. When palm is deflected by the edge of wire/ felt servo valve sends variable pneumatic pressure to the actuator which in turn swings the pendulum forward/ Reverse as the case may be. Servo valve controls both pressure and flow rate of compressed air proportional to magnitude and direction of signal generated by the palm. Servo system is provided with R.C. net work as well as Viscons damping device to ensure high frequency Response and adequate stability under all operating conditions. Enquire
	Air Supply Appropriate FRL unit of reputed make is to be used and ensure that supply Pressure is maintained at 5 to 6 bars under all conditions. Mounting Use lifting eye bolt for handling. Our standard design is such that it can easily be mounted in the “ T Slots” of the paper-machine-base. Lubrication Grease lubricants once a year at the nipple provided. Enquire

Spare Parts
Under normal circumstances this equipment will not need any spares for 5- 10 years of operation. In the event of any accidental damages please indicate the model No. and S.No. to enable us to send you replacement parts. After some 15 years or so it may need some rebuilding, replacing worn out pins, replacing servo valve etc. We under take to rebuild the unit, at that time, at nominal costs. Tubes and fillings used are of international standard- 1/8 inch BSP and you may replace them if any damage takes place during the course of its life. Do not change dia or length of piping, as it will interfere with original calibration.
Spare Palm Rods are supplied with AGP-200.
Guarantee
This equipment is guaranteed for a period of five years and defective parts, if any, will be replaced free of cost. Guarantee will be null and void if the servo-valve is dismantled and opened. It is calibrated unit and so it will get “ totally- lost” once dismantled. Settings of R.C.Circuit and dampener should also not be disturbed.

Enquire

	Low initial cost
	Low running cost needs no maintenance - fit & forget
	Based on " Beloit - USA " design.
	Very low air consumption.
	No sliding parts consequently no wear , no lubrication required .Roll reaction taken by sealed ball bearing , lubricated for life and operates at Zero speed , sensitive servo valve needs low contact pressure with web and provides fast response.
	Actuator has no wearing parts , moving seals , no friction and hence long maintenance free life
	Guaranteed for life.